1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
|
Install Debian using vmdb2 (v-i)
=============================================================================
WARNING!
-----------------------------------------------------------------------------
Warning: this is an operating system installer. It will overwrite your
hard drive and annihilate anything that used to be there. There are no
safety rails. You will lose all your data. Make sure your backups
work. You have been warned.
Introduction
-----------------------------------------------------------------------------
This is a hack for my own amusement. It's not meant to be taken
seriously.
This is a rudimentary installer of Debian based on vmdb2. It has
nothing to do with debian-install, the official Debian installer,
known as d-i. I use d-i, but would like something better:
* I'd like something I can easily modify. d-i requires building
special udeb packages for any software that's to be part of the
installer. v-i is happy with normal debs.
* d-i uses preseeding for automating an installation. Preseeding means
providing answers, in a file, to questions the package may ask
during its installation. This is fine, if a little cumbersome, but
only helps to answer questions the packages ask. v-i lets you have
the full power of Ansible during initial installation.
On the other hand, d-i is mature software and tested by thousands. v-i
can just barely install my own Thinkpad x220 laptop.
v-i is not currently expected to work with any other hardware.
Architecture
-----------------------------------------------------------------------------
The vmdb2-installer builds a bootable disk image with Debian. The
image boots with UEFI, and has everything you need to run vmdb2. You
write the image to a USB drive, boot off that, and run vmdb2 in the
booted system to install Debian onto the hard drive.
Thus:
- build system -> installer image
- installer image -> USB drive
- boot from USB drive
- run vmdb2 to install onto laptop hard drive
The image building uses vmdb2 as well. Things get a little recursive.
Hacking
-----------------------------------------------------------------------------
The main files are:
* v-i.vmdb -- the vmdb2 specification file for the installer image
* v-i.yml -- the Ansible playbook used by v-i.vmdb
* x220.vmdb -- the vmdb2 specification file to install onto an x220;
this is used from the system booted from the image built by v-i.vmdb
* x220.yml -- the Ansible playbook used by x220.vmdb
To build the installer image, run
~~~sh
sudo ./v-i.sh
~~~
To write the resulting v-i.img to a USB drive:
~~~sh
sudo dd if=v-i.img of=/dev/path/to/usb/drive/device status=progress oflag=direct
~~~
Plug in the USB drive to the laptop, boot off that. Log into the
installer as root (no password), and run
~~~sh
./x220.sh
~~~
Reboot laptop from its hard drive and you should have a bare bones
Debian system installed.
|
